HG Natural Stone Impregnating Protector

HG Natural stone impregnating protector
HG natural stone impregnating protector

HG natural stone impregnating protector is a special pre-treatment for marble and other types of natural stone such as travertine, blue stone, hard stone, etc., but is also extremely suitable for concrete tiles that contain pieces of natural stone, such as granite and marble composite. This unique product penetrates deep into the pores of the natural stone and thus stops its suction effect. This prevents the absorption of dirt and (grease) stains without affecting the original character of the natural stone or sealing the floor against moisture from below, allowing the floor to continue to 'breathe'.

Basic treatment for marble and other types of natural stone
- Prevents the absorption of dirt and (grease) stains
- Also suitable for granite and marble composite

This product contains no silicones, dries quickly, and is suitable for both indoor and outdoor use.

Composition
Contains methylisothiazolinone.

Use
1. The substrate must be completely clean, free of grease and dust. For any necessary treatments: See the HG natural stone floor treatment matrix on the side of this bottle.
2. The adhesive/mortar and joints of new floors must be fully cured and dry. This usually takes 4-6 weeks.
3. Existing floors must be thoroughly dry after cleaning; at least 3 days should be allowed for this.
Very porous tiles, such as sand-lime stone, however, need more time to completely lose the water. For this type of natural stone, we recommend taking at least 1 week for this. However, if the floor has underfloor heating, a drying time of 24 hours is sufficient. The underfloor heating must be turned off for at least 12 hours before treating with this product.
4. The liquid must be pure and, preferably, applied evenly and in one direction using a paint roller. On (high) gloss floors, this product should be applied and wiped with a non-fluffy cloth.
5. If it appears that some areas still have product on the natural stone 10 minutes after application, which has not been absorbed, it should be removed immediately with a dry, non-fluffy cloth.
6. For very porous tiles, a second treatment is recommended.
About 1 hour after the first treatment, a possible second layer can be applied.
7. Approximately 3 hours after the last treatment, the floor can be walked on normally again, and 12 hours after the last treatment
the floor is fully protected.

Consumption: Highly porous natural stone: ± 10-20 m2 per liter.
Low and high gloss natural stone: ± 20-50 m2 per liter.

Maintenance:
See the HG natural stone floor treatment matrix on the website www.HG.eu Tip:
If the floor is not provided with a specific top layer protection after treatment with this product, such as the HG natural stone protector (product 33), it is recommended to possibly repeat the treatment with this product locally every 1 to 2 years, especially in areas that are heavily used. The protection of the top layer by this product may decrease over time due to foot traffic.

Warnings
Contains methylisothiazolinone; May cause an allergic reaction.
P101- When seeking medical advice, keep the packaging or label available.
P102- Keep out of reach of children.

Transport and store the bottle upright.

The mixture consists of 2.08% of one or more components whose toxicity is not known.
Store frost-free.

For existing floors (which may have previously undergone an impregnating treatment), it is recommended to first conduct a test piece. This allows for determining how much product needs to be applied, preventing excessive use and the need to remove any surplus material later.

Data sheet for medical personnel can be requested via +31 36 54 94 777
Consumer information sheet is available at www.HG.eu

Manufacturer / Distributor
HG International BV, P.J. Oudweg 41, 1314 CJ Almere