Microlife Veterinary Thermometer 1831

Microlife Thermometer veterinary 1831

This thermometer is only suitable for measuring the animal body temperature.
• The minimum measurement time until the signal sounds (beep) must always be maintained.
• Protect the thermometer from damage due to dropping and hitting.
• Avoid ambient temperatures above 60 °C. Never boil the thermometer!
• Only use the common cleaning agents mentioned in the chapter "Cleaning and disinfecting" to clean the thermometer. The thermometer must be intact when
it is cleaned.
• The manufacturer recommends having the accuracy checked by an accredited laboratory every 2 years
- 10 seconds temperature measurement
- Automatic self-test & switch-off
- 100% waterproof
- Digital JUMBO LCD
- Memory of last measurement

What this product is used for
Measuring the body temperature of animals.

Instructions for use
To turn on the thermometer, press the button: a short signal (beep) indicates "thermometer on". A display test is performed. All possibilities are displayed. At an ambient temperature of less than 32 °C, "-- -" and a blinking "°C" are displayed in the upper right corner. The thermometer
is now ready for use/

During a measurement, the measured temperature is constantly displayed. The "°C" blinks during this period. When the signal sounds (10 times "beep") and the "°C" no longer blinks, it means that the measured increase in temperature is less than 0.1 °C per 8 seconds and that the thermometer can now be read.
To save battery, lightly press the off button to turn off the thermometer. Otherwise, after about 10 minutes, the thermometer will turn itself off.

If the button is held down for more than 3 seconds when the thermometer is turned on, the automatically stored maximum temperature of the last measurement will be displayed. At the same time, an "M" for memory will appear on the display field.
About 3 seconds after releasing the button, the temperature value disappears and the thermometer is ready to take a measurement.

Measurement method
In the anus (rectal)
Gently insert the measuring sensor of the thermometer
2 to 3 cm into the anal opening.
Measurement time approx.: 10 seconds.

The thermometer is 100% waterproof and may be fully submerged in water or
in disinfectant solutions. Then dry the thermometer with a damp cloth. Use one of the following disinfectant liquids for disinfection, according to the manufacturer's instructions.
Isopropyl alcohol 70 % - maximum 24 hours of immersion

Battery replacement
When the symbol "▼" (upside-down triangle) appears on the display field, the battery is empty and must be replaced. To replace the battery, the cover of the battery compartment of the thermometer must be removed. Insert a new battery with the + side facing up.
Make sure you have a battery of the same type on hand. Batteries can be purchased at any electronics store. For battery disposal, see "Important safety instructions".

Components
Thermometer with protective cover

Warnings
Only suitable for use on animals.

Other information
Medical device. Read the instructions for use before use.

Manufacturer / Distributor
Microlife AG,
Espenstrasse 139,
9443 Widnau,
Switzerland